Print

...get started

...get started

...get started

 

When you receive your GPS tracker, keep the packaging for a short time in case it's needed again.

Charge it using the charger and USB lead or charging mat (Bond Tracker) supplied.  When charging (~1 hour per 1000mAh of battery capacity, from flat) the red Power LED will flash every 2 secs until fully charged, whereupon it will flash green.  Please take a little time to familarise yourself with the tracker's features, especially the difference between the On/Off Power button and the Panic button, which are often mixed up. Bond or boxed-in trackers are enclosed Prime2s, so your cannot see their LEDs and they are always On.

 

Prime 1:                                                                                                       Prime2:
                     

Powering on and off

The Power button is recessed on the bottom edge. The large oval (Prime1) or round (Prime2) button in the device's centre is a Function button normally configured as an SOS or Panic button. It is NOT the On/Off button. Press the Power button while watching the LED lights, for about 3 seconds, then release it after the second flash of the green LED. The Power LED will flash green briefly then stop, after which the middle green GSM LED will start flashing every 4 secs to show that it has connected with the cell-phone network.  Then if the tracker is outdoors or near a window, the blue GPS LED will start light briefly when receiving a signal from the GPS satellites. The tracker's status on the panel changes from Device Off to Device On, then to Sleeping, if not moved for 90 secs.

To turn the tracker off, press and hold in the Power button until it flashs red twice, then release and let it boot down and report to the database that it is shutting down.  On the Track Panel its status will change from "Sleeping" or "Device On" to "Device Off".  When finished, all LEDs will be off.  When powering it on or off, try to hold the device with the LEDs visible.

GSM and GPS connection

Our GPS trackers can operate with much lower GPRS signal levels than a mobile phone.  When connected, the GSM LED will flash slowly (every 5 secs approx).  The GPS LED (blue) will flash only after it makes connection with the GPS satellites.  The first GPS connection takes much longer than subsequent connections, and is best done with as much clear sky visible as possible.  The tracker needs to pick up a very weak radio signals from GPS satellites far overhead. The device cannot be surrounded on all sides by a radio-opaque material like metal.

If the tracker is connected to an external power supply, it will automatically switch on when power becomes available / the ignition is switched on.  The process of turning the tracker on and off does not use a SMS or position credit, but it will send a few positions to determine whether it is moving or not.

The SOS button:

To send an immediate distress SMS message, press and hold the Function/SoS button for about 3-4 seconds.  Holding it longer than this may cause more than one SMS message.  The (mobile) phone number (or up to 4 numbers or email addresses) that are to receive the distress message must first be set up in the Admin section of the Track panel.  These people should be notified about the possibility of alert messages and what they should do if they get one.  
See: How To "...use the Tracking Panel" s

To configure your tracker, you must first install Microsoft Silverlight onto your computer/laptop.  See HowTo on ...install MS Silverlight.